Changing Oil in Your Car Essay -- Process Descriptive How To Changing

Changing Oil in Your CarWhen the average persons car needs an oil color change we perplex to a Quick Lube and have it done in 20 minutes. Another alternative would be to change the oil your self, this is a fairly unprejudiced process, most people with some common sense and some basic hand tools can do it at home on a weekend.The eldest step is finding out how much oil your car holds and what kind of oil filter fits on your cars engine. Your cars owners manual will have a electrical capacity section in the back, down the list till you come to the engine oil capacity, and the chart will list the number of quarts that your car needs. Also on most new cars when you can look on the oil cap it should state the oil weight which is recommended by the cars manufacturer. Then you need to go to the local anaesthetic parts house (I prefer Advance or Orileys) get the brand of oil that you prefer in the recommended weight, and quantity. When you pay, you can get the part number for the oil filter, all you have to know is the make of the car and the motor size and they should be able to find the information and then tell you which filter belongs on the car. Remember to get an oil filter wrench to remove the filter of with if dont already have one. Next, go home and find a level cut on which to park your vehicle. Before you jack up the front of the vehicle, you need to set the emergency brake and chock the rear wheels this is just a base hit measure to keep the car form rolling back. Once you have completed this, you need to refer to the owners manual again for the recommended lift points for the car. You atomic number 18 not able to just put a jack underneath a car and lift it up because you will risk damaging the under body. in that location are certain places to put the jack to properly ... ...place it in the fill hole (it is located on one of the valve cover of the motor and it has a cap) and kick in the recommended amount of oil. After you have added oil, re place the cap. Now you are ready to start the motor. When you first start it, there will be no oil pressure so dont be alarmed but watch the gauge, and in about ten to thirty seconds the oil pressure should be up in the normal range. With the engine running, look underneath the vehicle and check the plug and filter to make sure there are no leaks. If there are no leaks, shut the vehicle off and check the oil level on the dip stick and make sure it is between the low and across-the-board mark. If the oil is a little low, add a little more at a time, and keep rechecking it until the oil level is full. When you have completed this you are done. This is a fairly simple process and can save you a lot of money over time.